[Letux-kernel] [PATCH v3 3/3] ARM: dts: imx: add devicetree for Kobo Clara HD

Shawn Guo shawnguo at kernel.org
Sat Oct 26 10:12:15 CEST 2019


On Fri, Oct 25, 2019 at 08:07:43PM +0200, Andreas Kemnade wrote:
> Hi,
> 
> On Fri, 25 Oct 2019 21:46:24 +0800
> Shawn Guo <shawnguo at kernel.org> wrote:
> 
> [...]
> > > +
> > > +		pinctrl_wifi_reset: wifi_reset_grp {
> > > +			fsl,pins = <
> > > +				MX6SLL_PAD_SD2_DATA7__GPIO5_IO00	0x10059		/* WIFI_RST */
> > > +			>;
> > > +		};
> > > +
> > > +		pinctrl_wifi_power: wifi_power_grp {  
> > 
> > I guess you can have one pinctrl node to include both reset and power
> > pins?  Also, to be consistent with other pinctrl nodes on naming, the
> > node name should probably be wifigrp.
> > 
> well, the problems they are used in different nodes, so I cannot do
> that:
> 
>        reg_wifi: regulator-wifi {
>                 compatible = "regulator-fixed";
>                 pinctrl-names = "default";
>                 pinctrl-0 = <&pinctrl_wifi_power>;
>                 regulator-name = "SD3_SPWR";
>                 regulator-min-microvolt = <3000000>;
>                 regulator-max-microvolt = <3000000>;
>                 gpio = <&gpio4 29 GPIO_ACTIVE_HIGH>;
>                 enable-active-high;
>         };
> 
>         wifi_pwrseq: wifi_pwrseq {
>                 compatible = "mmc-pwrseq-simple";
>                 pinctrl-names = "default";
>                 pinctrl-0 = <&pinctrl_wifi_reset>;
>                 post-power-on-delay-ms = <20>;
>                 reset-gpios = <&gpio5 0 GPIO_ACTIVE_LOW>;
>         };

Ah, yes, it makes more sense.  I missed that.

Shawn

> 
> So having them combined breaks the mux where you use it rule.
> I got in earlier mails:
> 
> > > +	wifi_pwrseq: wifi_pwrseq {
> > > +		compatible = "mmc-pwrseq-simple";
> > > +		post-power-on-delay-ms = <20>;
> > > +		reset-gpios = <&gpio5 0 GPIO_ACTIVE_LOW>;  
> 
> > Can you add a pinctrl-entry here please? The general rule is to mux
> > things where you use it
> [...]
> > > +			compatible = "regulator-fixed";
> > > +			regulator-name = "SD3_SPWR";
> > > +			regulator-min-microvolt = <3000000>;
> > > +			regulator-max-microvolt = <3000000>;
> > > +
> > > +			gpio = <&gpio4 29 GPIO_ACTIVE_HIGH>;  
> 
> > Please add a pinctrl here to mux this gpio.
> 
> Regards,
> Andreas


More information about the Letux-kernel mailing list