[Letux-kernel] [PATCH v3 0/7] iio: adc: palmas_gpadc: add iio events
risca at dalakolonin.se
Wed Apr 5 23:22:26 CEST 2023
This series is based on linux-next/master  and .
The palmas gpadc block has support for monitoring up to 2 ADC channels
and issue an interrupt if they reach past a set threshold. This can be
configured statically with device tree today, but it only gets enabled
when reaching sleep mode. Also, it doesn't look like anyone is using it.
Instead of this one special case, change the code so userspace can
configure the ADC channels to their own needs through the iio events
subsystem. The high and low threshold values can be set for every
channel, but only 2 thresholds can be enabled at a time. Trying to
enable more than 2 thresholds will result in an error.
The configured thresholds will wake up the system from sleep mode if
wakeup is enabled in /sys/devices/.../power/wakeup.
The old platform data was removed.
Thresholds, events, and wakeup were tested on omap5-uevm board. It wakes
up from sleep mode when wakeup is enabled and a threshold is passed. A
userspace tool for monitoring events and adjusting thresholds can be
found at .
V2 -> V3:
* Rebased to linux-next.
* Avoid reconfiguring events on error and when old == new value.
V1 -> V2:
* Begin by removing adc_wakeupX_data instead of doing it last.
* Split changes in smaller patches
Patrik Dahlström (7):
iio: adc: palmas: remove adc_wakeupX_data
iio: adc: palmas: replace "wakeup" with "event"
iio: adc: palmas: use iio_event_direction for threshold polarity
iio: adc: palmas: move eventX_enable into palmas_adc_event
iio: adc: palmas: always reset events on unload
iio: adc: palmas: add support for iio threshold events
iio: adc: palmas: don't alter event config on suspend/resume
drivers/iio/adc/palmas_gpadc.c | 559 +++++++++++++++++++++++++++------
include/linux/mfd/palmas.h | 8 -
2 files changed, 464 insertions(+), 103 deletions(-)
More information about the Letux-kernel