[Letux-kernel] [PATCH v4] DTS: ARM: OMAP5: uevm: add µSD card detect

H. Nikolaus Schaller hns at goldelico.com
Mon May 15 10:31:16 CEST 2017


If we have Linux installed in eMMC we can boot without
µSD card, but inserting one is not recognised.

The reason is that the card detect gpio (gpio5_152)
is not configured and attached to the mmc1 interface
driver and the mmc driver does not poll by default.

Hence we add pinmux and gpio setup for the SDCARD_NCD
signal.

Signed-off-by: H. Nikolaus Schaller <hns at goldelico.com>
---
 arch/arm/boot/dts/omap5-uevm.dts | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/arch/arm/boot/dts/omap5-uevm.dts b/arch/arm/boot/dts/omap5-uevm.dts
index d58b034513da..1a6e28c3d847 100644
--- a/arch/arm/boot/dts/omap5-uevm.dts
+++ b/arch/arm/boot/dts/omap5-uevm.dts
@@ -142,6 +142,13 @@
 	};
 };
 
+&mmc1 {
+	pinctrl-names = "default";
+	pinctrl-0 = <&mmc1_pins>;
+
+	cd-gpios = <&gpio5 24 GPIO_ACTIVE_LOW>;	/* gpio5_152 */
+};
+
 &omap5_pmx_core {
 	evm_keys_pins: pinmux_evm_keys_gpio_pins {
 		pinctrl-single,pins = <
@@ -161,6 +168,12 @@
 			OMAP5_IOPAD(0x0a8, PIN_INPUT_PULLUP | MUX_MODE6)	/* gpio3_76 */
 		>;
 	};
+
+	mmc1_pins: pinmux_mmc1_pins {
+		pinctrl-single,pins = <
+			OMAP5_IOPAD(0x1d4, PIN_INPUT_PULLUP | MUX_MODE6)	/* gpio5_152 */
+		>;
+	};
 };
 
 &tpd12s015 {
-- 
2.12.2



More information about the Letux-kernel mailing list