<p>On Mar 3, 2013 2:36 PM, "Hermann Schwärzler" <<a href="mailto:hermann.schwaerzler@chello.at">hermann.schwaerzler@chello.at</a>> wrote:<br>
><br>
> Hello Everybody!<br>
><br>
> I am an owner of a gta04 (a4) but not of an GTA02 or similar so I am<br>
> lacking some parts to have a fully working phone.<br>
><br>
> Some days ago I found an old non-working Sony Ericson T230 while<br>
> rummaging in the "potential toys" drawer of my kids. I disassembled it<br>
> and found two parts that might work with my gta04:<br>
><br>
> 1. An earspeaker labeled "LTR711B" (see attachment "ltr711b..."). It is<br>
> rectangular in shape but seems to fit into the case (I am using a 3D<br>
> printed one) if I take a sharp knife to square the circle that normally<br>
> takes the earspeaker. I plan to solder/glue some kind of "adapter" to<br>
> the speaker in order to put the contacts of the speaker to the right spot.<br>
> But there are some questions I have w.r.t. this:<br>
>  * Impedance: I measured 30 Ohms with my multimeter which is<br>
>    promising, as it should be 32 Ohms, shouldn't it?<br>
>    But do multimeters measure restistance using AC?</p>
<p>They normally use DC.<br>
>  * If I put it into place it will cover two contact-points<br>
>    (see attachment "covered_contacts"). These are labeled "RFID+" and<br>
>    "RFID-" in the manual (last page).<br>
>    Is this a problem? What are those used for?</p>
<p>I guess those pads are meant for near field communication (RFID) which is a short range transiver.</p>
<p>I suggested to cover them and anything else in the area with tape to avoid possible short circuits.</p>