[Letux-kernel] [PATCH v2] musb: omap2430: do not assume balanced enable()/disable()
andreas at kemnade.info
Thu Aug 4 18:44:02 CEST 2016
On Thu, 4 Aug 2016 18:31:29 +0200
Andreas Kemnade <andreas at kemnade.info> wrote:
> On Thu, 4 Aug 2016 07:29:19 -0700
> Tony Lindgren <tony at atomide.com> wrote:
> > Hi,
> > * H. Nikolaus Schaller <hns at goldelico.com> [160803 10:07]:
> > > All this prevents detection of cable plugin-events and VBUS
> > > measurement and setting OTG_EN before charging is attempted.
> > So I gave this patch a try but it now blocks all deeper SoC idle
> > states as the PHY stays active. I think the real fix is to make
> > sure the charger behaves independent of the USB PHY state. So
> > probably this needs to be fixed in phy-twl4030-usb.c and
> > twl4030_charger.c instead. Now it sounds like we're also shutting
> > down the charger with the USB PHY.
> Then there is another power management issue. The patch is not about
> fixing every pm issue in musb. That is not only about charging, it is
> about enabling/disabling() the phy unbalanced:
> Again what happens here without the patch:
> musb will be initialized:
> calls phy_power_off(), phy will be disabled,
> phy->power_count goes to -1.
sorry mixed something up.
Nothing happens here, so the previous state of the phy remains.
It would be disabled by the generic phy layer in drivers/phy/phy-core.c
> gadget driver is loaded.
> musb_start() is called
> omap2430_musb_enable() is called
> calls phy_power_on(),
> phy->power_count goes to 0,
> phy is not powered on because power_count != 1
> -> no gadget working, no charging.
... if not configured by u-boot before. USB gadget might work when
initialized earlier in the boot process (u-boot/x-loader/mlo ...)
and phy-twl4030 cannot do anything about it besides if we change
More information about the Letux-kernel